Cover Components - Air Insert Adjustment - Permobil ROHO AGILITY Operación Manual

Cover Components - Air Insert Adjustment

Warnings:
- Check inflation frequently, at least once a day!
- The air insert must be used with the air cells facing the individual.
- The individual's comfort level may be reduced if an air insert is not positioned correctly, is not properly sized to the foam pad, or is
under-inflated or over-inflated.
- If an air insert does not appear to be holding air, see T
the air insert is still not holding air, replace the air insert with the foam
insert and contact ROHO, Inc. or your equipment provider.
- Changes in altitude may require adjustment to an air insert. Check the
inflation level of any air inserts when changing altitude.
Cautions:
- If an air insert has been in temperatures less than 32°F / 0°C and exhibits
unusual stiffness, allow the air insert to warm to room temperature, then
open the inflation valve. Roll up the air insert and then unroll it until the
polyurethane is soft and pliable again. Repeat adjustment instructions
before using.
- Keep air cells away from sharp objects.
To Adjust the Air Insert
Notes: Before you adjust the air insert, make sure the cover with the foam pad and air insert are correctly installed on the back shell.
Make sure that the AGILITY is correctly installed and adjusted on the wheelchair.
1) Slide the rubber nozzle of the hand pump over the inflation
valve. Pinch the nozzle and open the inflation valve. Inflate the
air insert until it feels firm.
Open
Warning: Safely transfer the individual into the wheelchair.
3) The individual may be seated in the wheelchair in their
normal position. Open the inflation valve. Remove air until the
individual is comfortable. Close the inflation valve.
Open
ROHO AGILITY Back System Operation Manual
. If
roubleshooTing
DO NOT:
- use an air insert as a seat cushion.
- expose an air insert to high heat, open flames or
hot ashes.
- use the valve hose as a handle to carry or pull an
air insert.
- use an air insert as a water flotation device (e.g., a
Life Preserver).
- use both an air insert and a foam insert together.
- use a pump, cover, foam pad or repair kit, other
than those provided by ROHO, Inc., with an air
insert. Doing so may void the product's warranty.
2) Pinch the rubber nozzle of the hand pump and close the
inflation valve completely. Remove the hand pump.
Warning: Safely transfer the individual out of the wheelchair.
4) Detach the flap closest to the zipper. Place the valve hose inside
the zipper. Zip the cover closed and reattach the flap.
Close
7
Close