Cover Components - Air Insert Adjustment - Permobil ROHO AGILITY Max Contour Back Support Manual Del Usuario

Cover Components - Air Insert Adjustment

Warnings:
- Check inflation frequently, at least once a day!
- The air insert must be used with the air cells facing the individual.
- The individual's comfort level may be reduced if an air insert is not
positioned correctly, is not properly sized to the foam pad, or is under-
inflated or over-inflated.
- If an air insert does not appear to be holding air, see "Troubleshooting".
If the air insert is still not holding air, replace the air insert with the foam
insert, and contact an equipment provider or Customer Support.
- Changes in altitude may require adjustment to an air insert. Check the
inflation level of any air inserts when changing altitude.
To Adjust the Air Inserts
Notes: Before you adjust the air inserts, make sure the cover with the foam pad and air inserts is
correctly installed on the back shell. Make sure that the AGILITY is correctly installed and adjusted
on the wheelchair.
Follow these instructions to adjust the air insert and the two wing air inserts.
1. Slide the hand pump nozzle over the inflation valve. Open the inflation valve, at least one full
rotation. Inflate the air insert until it feels firm.
Note: The inflation valve will spin freely when open.
2. Close the inflation valve until it comes to a stop. Remove the hand pump. Make sure the
inflation valve is closed.
Warning: Safely transfer the individual into the wheelchair.
3. Adjust the air insert, if desired:
a. The individual may be seated in the wheelchair in their normal position.
b. Open the inflation valve and remove air until the individual is comfortable. Close the inflation
valve. Make sure the inflation valve is closed. Follow the valve hose placement instructions.
Valve Hose Placement
With the cover installed on the back shell, place the valve hoses in the cover:
Air insert:
Note: The valve hose should
be accessible, as shown. If the
valve hose is not accessible, see
"Cover Components Installation" :
"Installing the Cover on the Back
Shell - Valve Hose Placement".
Tuck the valve hose into the side
pocket.
ROHO AGILITY Max Contour Back Support Operation Manual
- DO NOT use the valve hose as a handle to carry or pull an air insert.
- DO NOT use an air insert as a water flotation device (e.g., a Life Preserver).
- If an air insert has been in temperatures lower than 32° F (0° C) and exhibits
unusual stiffness, allow the cushion to warm to room temperature. Repeat
adjustment instructions before using.
- Keep air cells away from sharp objects.
- DO NOT use an air insert as a seat cushion. DO NOT use an air insert and a
foam insert together.
- DO NOT use a pump or repair kit other than those approved for use with an
air insert.
7
Cautions:
Wing air inserts:
Tuck the valve hoses into the
right and left side pockets.
Open Close