Belt Maintenance; Maintenance Table - Tornado 97560T Manual De Instrucciones

BELT MAINTENANCE

(WARNING: REMOVE LP TANK BEFORE TURNING OVER THE MACHINE)
To change a broken or worn belt, turn the machine on its side and remove the pad and pad driver. Using
a wrench, loosen the hex bolt for the pulley tensioner. Once the tensioner is loose, the belt can be easily
removed. Slip the old belt off the pulleys and reattach the new belt. Attach the pulley tensioner back into
position and retighten its bolt. The tensioner should provide the belt with a 0.16 inch belt deflection when
a force of 2 pounds is applied against outside of belt. Turn machine upright immediately after service is
completed.
These are typical service intervals. Service more frequently under more severe operating conditions.
Type of Service
Check Oil for Proper Fill Level
Check Bonnet Air Filter for Obstruction
Check Cleaning Pad for Wear
Check Drive Belt Tension
Inspect for Loose Bolts & Connections
Change Engine Oil ++
Clean Air Cleaner Foam Element
Clean Air Cleaner Paper Element
Tighten Nuts, Screws, & Brackets
Clean and Adjust or Replace Spark Plug
Clean Engine Cooling Fins
Change Oil Filter
Replace Air Cleaner Paper Element
Adjust Engine Valve Clearance
Clean and Lap Valve Seats
Clean Cylinder Heads of Deposits
Recertify Emission Control System
KD = Have an authorized Kawasaki Engine Dealer perform these services.
^^ = Re-certify machine to meet EPA and CARB SORE Regulations
++
MOTOR OIL: Consult the Kawasaki Owners Manual for oil viscosity recommendations.
General capacity of engine oil is 1.9 US quarts. Oil level must be checked when engine is tilted forward
Description
Air Filter
Air Pre-Filter
Spark Plug
Oil Filter
Steel Propane Tank w/Gauge

Maintenance Table:

Daily First Every Every
8 Hrs. 25 Hrs. 50 Hrs. 100 Hrs. 200 Hrs. 300 Hrs. 500 Hrs.
++
•
•
•
•
• •
•
•
•
Catalog #
KW11
KW11A
KW40
KW5
30396
11
Every Every Every
•
•
•
•
KD
KD
KD
Every
^^