Overflow Device; Stop Of The Machine After Cleaning Operation; Daily Maintenance; Recovery Tank Cleaning - Tornado 99732 Manual De Operaciones Y Mantenimiento

ATTENTION:

OVERFLOW DEVICE

In order to avoid serious dam-
ages to the suction motor, the
machine is equipped with a
float that intervenes when the
recovery tank is full, closing the
suction hose and stopping the
suction.
When this happens, it is neces-
sary to empty the recovery tank.
1. Hold the exhaust hose placed
in the front part of the machine.
2. Take off the exhaust plug
acting upon its lever and empty
the recovery tank into appropri-
ate containers, according to the
standard norms.
ATTENTION:
This operation must be carried
out using gloves to protect from
contact with dangerous solu-
tions.
STOP OF THE MACHINE AF-
TER CLEANING OPERATION
Before executing any type of
maintenance:
1. Turn the brushes motor
switch off (6).
2. Turn the suction motor switch
off (3).
3. Lift the brushes base from the
floor.
The machines which have the
brushes base lifting electrically
done press the push button (7)
of up/down of the brushes base.
4. Lift the squeegee acting upon
the lever (17).
5. Bring the machine to an ap-
propriate place for tanks drain-
ing.
6. Turn the key (9) counterclock-
wise.
7. Insert the parking brake (16).

DAILY MAINTENANCE

RECOVERY TANK CLEANING

1. Hold the exhaust hose placed
in the front part of the machine.
2. Take off the plug of the ex-
haust hose acting upon its lever
and empty the recovery tank
into appropriate containers.
3. Take off suction cover after
rotating the blocking levers.
4. Take off the filter and filter
protection.
5. Take off the inspection cap of
the recovery tank.
6. Rinse the tank with a water
jet from both openings.
17
ATTENTION:

SUCTION FILTER CLEANING

1. Take off suction cover (2)
after rotating the blocking levers
(1).
2. Take off the filter and filter
protection.
3. Clean all parts with a water
jet especially the inside surfaces
and the filter bottom.
4. Carry out cleaning operations
carefully.
5. Reassemble all parts.

BRUSHES CLEANING

Disassemble the brushes and
clean them with a water jet
(check under paragraph of
"BRUSHES DISASSEMBLY").