Preparing The Rack Enclosure; Preparing The Chassis; Rack-Ready Server - Sun Microsystems Enterprise 250 Manual De Montaje

The rackmounting kit also contains the following screws and nuts, shown actual
size.
#10 flathead #10 SEMS panhead
screws (2)

Preparing the Rack Enclosure

1. Turn off the AC power to the rack enclosure and remove the front and rear panels, if
applicable.
See the instructions provided with the rack enclosure.
2. Stabilize the rack enclosure by extending its anti-tilt legs or bolting the rack securely to
the floor.
See the instructions provided with the rack enclosure.

Preparing the Chassis

Rack-Ready Server

If you purchased a rackmount configuration of the Sun Enterprise 250 server, the plastic
side panels have been removed and a rack-ready side access panel has been installed.
Before you install the rack-ready server in the rack enclosure, you need to:
Attach the inner glides and the stop bracket to the chassis—page 1-14
M4 SEMS panhead
screws (14)
screws(20)
M4 KEPTS nut (14)
How to Rackmount the Sun Enterprise 250 Server 1-7