Mount Product - Festo ESBF-BS Serie Instrucciones De Utilizacion

ESBF-BS/-LS-32 ... 100
5.1.1

Mount product

Note
Pulling out of screws if cylinder is only mounted to the covers and the torque load
around the collar is too great.
• If there are heavy loads, mount the cylinder to the profile with additional mounting
components.
• Place ESBF as follows:
– all control sections are accessible
– Pressure compensating opening 4 (è Fig. 1) is not covered.
Interfaces for mounting components
on the cover
e.g. with flange mounting EAHH
8
Fig. 6
• Select mounting components or accessories (è www.festo.com/catalogue).
• Mount the mounting components outside the positioning range (avoid collisions).
• Select mounting elements so that internal torques are braced against the housing during powerful
acceleration phases.
• Mount cylinder without distortion and deflection.
• Tighten screws 8 uniformly to the specified tightening torque.
Size
Screw
Tightening torque
Tab. 1
Note
If an EAGF guide unit is used:
• Mount construction kits for proximity switches outside the mounting area of the
EAGF (è Assembly instructions).
Festo – ESBF-BS/-LS-32 ... 100 – 1504a English
on the profile
e.g. with profile mounting EAHF
32 40
8
M6 M6
[Nm] 6 6
corrie
50 63 80
M 8 M 8 M10
12 12 25
100
M10
25
23