Start-Up; Operating Modes - KBL megaSun Serie Manual De Usuario

Start-up

Before switching on for the first time:
•
Fix the supplied warning sign or one with the
following wording permanently to the wall close to
the tanning unit:
• UV radiation can cause eye and skin injury. Ask the studio
staff for further information.
• Wear protective goggles.
• Certain medicines or cosmetics can increase the sensitivity
of the skin to UV radiation.
After the power up:
•
Determine the presettings for the sunbed in the
service menu.
•
Store these Operating Instructions in a place that
allows for easy access at any time.

Operating modes

The three different operating modes are explained
below:
STANDBy MODE
The unit is in an idle state, i.e. it is connected to the
mains but is currently not being used. The tubes and
the tanning lamps are switched off. From the standby
mode, you can change over to the tanning mode or
to the service mode.
TANNING MODE
The tubes and the tanning lamps are switched on
and a tanning session is in progress. While the unit is
in tanning mode, the settings for the ongoing tanning
session can be changed via the control panel.
12
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
Warning!
FAN RUN-ON
After the tanning session, the fan runs on for 3
minutes in order to cool down the tanning system.
The fan power is automatically decreased as the
tubes cool down.
SERVICE MODE
In the service mode, the device is configured for the
tanning mode. Various values can be displayed and
test functions can be carried out.