Audio System With Mp3 Sound Box; Recording To An Sd Card - KBL megaSun Serie Manual De Usuario

MAINTENANCE OF ThE CONDENSATE PUMP
The condensate pump is controlled by the processor
in such a way that it is switched on every 5 minutes
for 20 seconds during a tanning session. After the
session, the pump continues operating.
Always check the proper functioning of the
condensate pump when you replace tubes.
•
Start the tanning program.
•
Open the front cover and slowly pour water into the
condensate tray.
•
The water must be pumped off. The unit must
remain connected to the power supply after the
tanning session in order to enable the run-on of the
pump.
•
The condensate hose must be guided into the
canister without any kinks and up to a level that
does not exceed the installation level by more than
25 cm.
Audio system with mp3 sound
box
In the lower part there are, inter alia, the components
for:
• megaVoice, the acoustic user guide,
• mp3 sound box for the "Music" option, and
• I2C audio switch
The audio switch is used for I2C bus adaptation,
for connecting an external audio signal with volume
control and the connections to the MP3 players.
The memory card for the mp3 sound box can be
exchanged after opening the front panel and pull out
the ballast trolly.
Figure 40.1: SD card ; push to disengage, then pull out.
40
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
Figure 40.2: SD card; slide in till it engages

Recording to an SD card

Please refer to the chapter "Technical data" for
information on supported card sizes as well as file-
system and MP3 formats.
Using the SD Writer software (download from http://
www.kbl-support.de/software/software.html),
can add or delete audio files to the SD card for music
at your convenience. These tracks are played after
the corresponding source has been selected. The
number of files is limited by the storage capacity of
the SD card.
1. Insert the card into the computer.
2. Activate SD Writer and copy files onto the card.
3. Insert the card into the MP3 player.
4. Restart the device. To do so, pull out the main plug
and plug it in again. In this way, you make sure
that the MP3 player will identify the SD card.
•
The SD card must only be formatted
using FAT16!
•
Only change the data of the MUSIC
MP3 player!
you
WARNING!