Canopy Drive - KBL megaSun Serie Manual De Usuario

Canopy drive

REGULAR MAINTENANCE
Check and maintain the drive rope after each
tube replacement in order to ensure a trouble-free
operation of the drive.
•
Check the canopy drive: the canopy must stop
in all positions. If not, the canopy spring must be
tensioned.
•
Should individual rope wires be spliced, replace
the rope immediately!
•
Use the spray lubricant hhS 2000 to grease the
rope in the area of the return pulley.
REPLACING ThE SPRING ROPE
Procedure
1 Close the canopy.
Remove the front cover of the base
2
section.
De-tension
3 the position of the nut at the spring
tensioner.
4 Remove the cover of the return pulley. 38.2
5 Remove the upper rope cover.
Undo the dowel screw of the upper
rope holder. Do not forget to remember
6
the position of the screw within the
seat opening
Replace the old rope and fasten the
7
new one.
Tension the spring in such a way that
9
the canopy stops in all positions.
Grease the rope in the area of the
10
return pulley.
11 Fasten all covers.
38
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
the spring. Remember
(figure 39.3, zoomed).
Figure 38.1: Spring tensioner in the base section (right-hand side)
Figure 38.2: Return pulley area with and without cover
Fig.
37.1
37.2
38.1
38.3
Figure 38.3: Upper rope holder with and without cover
38.3
38.1
38.2