Level Adjustment; Operation Using Different Audio Sources - KBL megaSun Serie Manual De Usuario

Level adjustment

The components of the voice/audio system are
built into the base section of the tanning unit. The
potentiometer (see arrow ), which is located on the
audio switch board, must be set to the maximum
volume level. Line adjustment of the studio music is
performed via the line box.
Figure 9.1
Operation using different audio
sources
The tanning unit can be operated using the following
audio sources:
•
An internal MP3 player alone
•
An external audio source alone
•
Both audio sources
Use the control panel to alternate between internal
and external audio source.
INTERNAL MP3 PLAyER
When using the internal MP3 player, you can either
play the music tracks that are originally supplied on
the SD card, or you can record your own tracks on
the SD card.
EXTERNAL AUDIO SOURCES
As an external audio source, you can connect
devices ranging from the standard-line level to low
loudspeaker levels.
These sources comprise:
•
the studio music, and
•
external players such as MP3 players, mobile
phones (cell phones), iPods, etc.
STUDIO MUSIC
The level of the studio music can be adjusted by
means of a potentiometer on the line box. The box is
located below the bed, on the right-hand front side
. It is only fixed by Velcro tape and can be
(figure 9.2)
removed.
Figure 9.2
This is where you can adjust the studio music to the
level of the integrated MP3 player.
Figure 9.3
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
9