Information About Operation; Displaying The Operating Hours Of The Solarium; Displaying The Operating Hours Of The Tubes; Resetting The Operating Hours Of The Tubes - KBL megaSun Serie Manual De Usuario

KBL5 and KBL4 processors use different software variants! The KBL5 menu only contains a subset of the setting
options available in the KBL4 menu. The order of the following information refers to the KBL4 menu. KBL4 menu
items are labelled ④. Items pertaining to the KBL5 menu are additionally marked ⑤.

Information about operation

Select the menu item
the working hours of the tanning system (
operating hours of the tubes (
Displaying the operating hours
of the solarium
The menu item xxxxxh WORK
the operating hours of the tanning unit.
1. Invoke the display of the operating hours (xxxxxh
WORK)
by pressing 0 (minus button) or 5 (plus
button).
2. Press STOP to exit the menu.
Displaying the operating hours
of the tubes
xxxxxh TUBE
The menu item
operating hours of the solarium's tubes.
1. Invoke the display of the operating hours of
the tubes (xxxxxh
button) or 5 (plus button).
2. Press STOP to exit the menu.
Resetting the operating hours
of the tubes (KBL4/KBL5)
④⑤
Use the menu item
the operating hours of the tubes to zero for inductive
and CPI-equipped units. These tube hours must be
reset after each replacement of tubes.
1. Invoke the PIN II
26
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
Settings on service level I
Operation-Info
to display
WORK
TUBE
).
④⑤
is used to display
④⑤
is used to display the
TUBE) by pressing 0 (minus
④
CPI RESET (KBL )
menu and enter the PIN.
④ 2. Press 5 (plus button) or 0 (minus button) to select
CPI
.
3. Press START to open
), the
4. Keep 1 (plus button) pressed as long as necessary
to set the hours to zero.
5. Press START to save the settings, then exit the
menu using the STOP button.
Use the menu item
reset the operating hours of the tubes to zero. These
tube hours must be reset after each replacement of
tubes.
1. Press 5 (plus button) or 0 (minus button) to select
RESET h TUBE
2. Keep 1 (plus button) pressed as long as necessary
to set the hours to zero.
3. Press START to save the settings, then exit the
menu using the STOP button.
Setting the timer function of
the decorative lighting
The menu item
pairs of times per day at which the decorative lighting
is automatically switched on and off (e.g. Monday at
10:00 h on, at 12:00 h off, at 13.00 h on again, and
at 22:00 h off, Tuesday at 11:00 h on, at 22:00 h off,
etc.). If a switching time is not required, it can be
deleted by pressing 1.
to reset
1. Invoke the
2. Select the days of the week with START and then
press 5 (plus button) or 0 (minus button) to set the
desired day.
3. Press START to invoke
CPI RESET .
RESET h TUBE (KBL
.
TIME/DATE allows you to enter two
TIMER
menu.
AON
and set the desired
⑤
) to
④