Connecting The External Timer; Connecting The Channel Selection - KBL megaSun Serie Manual De Usuario

EXTERNAL PLAyERS
A line-in connector is available in the head area of
the bed, on the right-hand side, so that the studio
client can plug in his/her own equipment, e. g. MP3
player, iPod, etc.
(figure 10.1)
jack cable (included if the music option has been
ordered). If an external player is plugged into this
connector, the system switches over automatically
and plays the music of the personal player. This
assumes that you have selected the "Studio" option
of the menu item "Audio" in the service menu I.
you can adjust the level by using the volume control
of either the control panel or the player.
Figure 10.1
The tanning unit can only be operated with audio
sources if you have purchased the optionally available
audio package. For further information, please refer
to the chapters "Connections" and "Operation in
service mode".
10
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
. Use a standard 3.5 mm

Connecting the external timer

Connect the external timer (coin box, studio control)
according to the instructions supplied with the timer.
The following diagram shows the wiring requirements
with regard to the timer.
Figure 10.2
Wiring on the coin box/external timer
L N
1 2 3 4
Connecting the channel
selection
The following diagrams show the wiring of the
channel selection on the audio equipment's side, for
Wiring on the audio system of the studio
pulse coding and for BCD coding.
Wiring on the audio system of the studio
1 2
1 2
Wiring on the audio system of the studio
Wiring on the audio system of the studio
1 2
1 2
ChANNEL
1
2
3
4
5 6 PE
Figure 10.3
3 4 5 PE
3 4 5 PE
Figure 10.4
3 4 5 PE
3 4 5 PE
BCD CODING
0 0
1 0
0 1
1 1