Filter Pads - KBL megaSun Serie Manual De Usuario

DECORATIVE TUBE IN ThE BASE SECTION
The coloured fluorescent tube in the base part is
located behind the front cover, underneath the bed
pane. Proceed as follows to replace this tube:
•
Remove the front cover. It is fixed with screws
at two places along the upper edge (
and engaged in notches at the side
37.1)
edges ( . The following photos show
figure 37.2)
how the cover is fixed on the left-hand side.
Figure 37.2
•
The fluorescent tube is now freely accessible and
can be replaced. The starter is located on the left-
hand side. Also replace the starter
when replacing the tube.
Figure 37.3

Filter pads

CLEANING CyCLE
The cooling air is sucked in via two dust filters.
Depending on the location, clean the filter pads
after approx. 100 hour of operation, or replace
figure
them, if necessary. Only use original filter pads for
replacement in order to ensure a troublefree operation.
Take the opportunity to check if the heat exchangers
inside the air-conditioning unit are soiled. Dirty heat
Figure 37.1
exchangers substantially reduce the performance
of the air-conditioning unit. Vacuum-clean them if
necessary.
FILTER PADS IN ThE CANOPy AND IN ThE BASE
SECTION
The filter pad of the canopy section
located in the gripping profile of the canopy; the filter
pad of the base section
front lighting. The pads can simply be removed and
cleaned or replaced.
(figure 38.3, zoomed)
Figure 37.5
(figure 37.5)
M a n u a l d e u s u a r i o | megaSun 4000 / 4500
is
(figure 37.4)
is fitted behind the
Figure 37.4
37