Worksheet - RIDGID RT3422 Manual Del Operador

RT3422 Tapping Tool

Worksheet

Pipe Identification Code Marking
Media
Pressure
Actual Pipe Type and Size
Identified By
Saddle or Thread-O-Let™ Manufacturer
Part Number
Designed Saddle Pipe Type & Size
(Must match pipe data above)
Designed Saddle or Threadolet Pressure Rating
(Must exceed main pressure)
Outlet Size
Installed / Welded Date
Installed / Welded By
Inspected Date
Saddle or Thread-O-Let™ Installation Approved By
Valve Manufacturer
Part Number
Valve Type & Size
Valve Pressure Rating (Must exceed main pressure)
Valve Approved By
Datum Offset (see Figure 6)
Datum to Full Stroke (see Figure 7)
Subtract "Datum Offset" from "Datum to Full Stroke" for
"Full Stroke Distance"
Valve Standoff Distance (see Figures 8 & 9) (Note if Full
Stroke Distance – 1" = Valve Standoff Distance then
ABORT THIS TAP!)
Maximum Stroke (photo 10) (Note if Maximum Stroke is
less than Full Stroke Distance be warned that penetration
of the back of the pipe is possible! Observe Unusable
Stroke Remainder (see Figure 12) to execute this tap
safely!)
Add Valve Standoff Distance to Maximum Stroke then di-
vide result by 2 for Ideal Penetration Distance
Subtract Ideal Penetration Distance from Full Stroke
Distance for Unusable Stroke Remainder. (Figure 12)
1.800.561.8187 information@itm.com
Ridge Tool Company 13
www. .com