Wilo Flumen OPTI-TR 20-1 Instrucciones De Instalación Y Funcionamiento página 25

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
2
10
11
8
13
Fig. 10: Mixer set down on the fixed limit stop
Fig. 11: Lifting equipment secured with cable
bollard
Installation and operating instructions Wilo-Flumen OPTI-TR 20-1, 28-1, 30-1, 40-1 Wilo-Flumen EXCEL-TRE 20, 30, 40
Installation and electrical connection
Completing installation
1
Hoist
2
Lifting equipment
8
Guide pipe for lowering device
10
Connection cable
11
Cable bracket with snap hook, cable routing via lifting equipment
12
Cable bracket with snap hook, safeguard against falling
13
Fixed limit stop
12
Mixer mounted on the lowering device
1. Slowly lower the mixer.
2. Hang the connection cable on the lifting equipment using the cable brackets.
The connection cable is routed safely using the lifting equipment (e.g wire rope). CAU-
TION! If no cable brackets are used to route the connection cable, ensure that the
connection cable is not pulled into the propeller!
3. Lower the mixer to the end of the guide pipe or until it reaches the fixed limit stop.
4. Secure the connection cable to the railing or hoist to prevent it from falling!
5. Check the swivel area of the lowering device.
Check the entire swivel area of the lowering device. The mixer must not crash into any
structures (fixtures, basin wall). CAUTION! If the entire swivel area is not made usable,
mechanically limit the swivel area!
6. Set the desired angle and install a screw to secure the lowering device against further
adjustments.
▶ Installation is complete. Lay the connection cable and make the electrical connection.
Mobile hoist: Installing a cable bollard
If a mobile hoist is used, install a cable bollard at the edge of the basin:
▪ Remove lifting equipment (e.g. wire rope) from the hoist and secure it to the cable bollard.
▪ Secure the connection cable at the edge of the basin to prevent it from falling.
CAUTION! If the connection cable leads over the edge of the basin, beware of potential
abrasion. Sharp edges may damage the connection cable. Bevel the basin edge if neces-
sary!
en-US
25

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido