Ground And Wall Fixation; Using A Lowering Device - Wilo Flumen OPTI-TR 20-1 Instrucciones De Instalación Y Funcionamiento

8.4.1

Ground and wall fixation

8.4.2

Using a lowering device

Installation and operating instructions Wilo-Flumen OPTI-TR 20-1, 28-1, 30-1, 40-1 Wilo-Flumen EXCEL-TRE 20, 30, 40
Decommissioning/removal
WARNING
Risk of burns due to hot surfaces!
The motor housing can get hot during operation. This can lead to burns. Allow the motor
to cool down to ambient temperature after switching off!
NOTICE
Use only technically faultless lifting equipment!
Use only technically faultless lifting equipment to lift and lower the mixer. Make sure that
the mixer does not jam during lifting and lowering. Do not exceed the maximum bearing
capacity of the lifting equipment! Check that lifting equipment is functioning properly
before use!
‡
Mixer decommissioned.
‡
Operating space emptied, cleaned and, if required, disinfected.
‡
Mixer cleaned and, if required, disinfected.
‡
Ensure work is carried out by two persons.
1. Disconnect mixer from power supply.
2. Disconnect and wind up the connection cable.
3. Enter the operating space. DANGER! If the operating space cannot be cleaned and
disinfected, wear protective equipment according to the work regulations!
4. Uninstall mixer from the basin wall or the basin floor.
5. Set the mixer down on a pallet, secure it against slipping and lift it out of the operating
space.
▶ Removal is complete. Clean and disinfect the mixer thoroughly.
‡
Mixer decommissioned.
‡
Protective equipment put on according to work regulations.
1. Disconnect mixer from power supply.
2. Disconnect and wind up the connection cable.
3. Insert lifting equipment in hoist.
4. Slowly lift mixer and remove it from the basin. During the lifting procedure, remove the
connection cable from the lifting equipment and wind it up.
DANGER! Mixer and connection cable come directly out of the fluid. Wear protective
equipment according to work regulations!
5. Swivel mixer and set it down on a firm surface.
▶ Removal is complete. Clean mixer and set-down location thoroughly, disinfect if re-
quired and store.
en-US
35