General; About This Manual; Note On Conformity; Copyright - Wilo Flumen OPTI-TR 20-1 Instrucciones De Instalación Y Funcionamiento

en-US
1

General

1.1

About this manual

1.2

Note on conformity

1.3

Copyright

1.4

Subject to changes

1.5

Warranty

2

Safety

6
General
The 'Installation and operating instructions' are an integral part of the product. Read these
instructions before all activities and keep them accessible at all times. Strict observance of
these instructions is a prerequisite for the intended use and correct handling of the product.
Observe all information and markings on the product.
The language of the original operating instructions is German. All other languages of these
instructions are translations of the original operating instructions.
This product was developed and manufactured in accordance with the applicable EU prod-
uct directives, to which all products sold in the EU must conform.
This product therefore complies with the relevant, general safety and health requirements
of the European Union, as well as the published European standards and internationally rec-
ognized German standards.
Since this product was not intended to be sold and used in the European Union, it does not
have a CE marking. It is therefore not permitted to sell it in the European Union.
These 'Installation and operating instructions' have been copyrighted by the manufacturer.
The content, of any kind, may not be reproduced, distributed or used for any competitive
purpose without authorization and handed to third parties.
The manufacturer reserves the right to make technical modifications to the product or indi-
vidual components. Illustrations used may differ from the original and serve only as example
illustrations of the product.
For the warranty and warranty period the specifications according to the current "General
Terms and Conditions" apply. You can find these here: www.wilo.com/legal
Any deviations must be contractually agreed and shall then be given priority.
Warranty
If the following points have been adhered to, the manufacturer is obliged to repair any qual-
itative or constructive defects:
▪ The defects were reported in writing to the manufacturer within the warranty period.
▪ Application according to intended use.
▪ All monitoring devices are connected and were checked before commissioning.
Disclaimer
A disclaimer rules out any responsibility for personal injury, material damage or financial
losses. This exclusion of liability follows as soon as one of the following points applies:
▪ Inadequate configuration due to unsatisfactory or false information from the operator or
employer
▪ Non-compliance with the 'Installation and operating instructions'
▪ Improper use
▪ Improper storage or transport
▪ Faulty installation or dismantling
▪ Insufficient or incorrect maintenance
▪ Unauthorized repairs
▪ Unsatisfactory building site
▪ Chemical, electrical or electrochemical influences
▪ Wear
This section contains basic information for the individual phases of the life cycle. Failure to
observe this information will result in the following risks:
▪ Danger to persons due to electrical, mechanical and bacteriological effects as well as elec-
tromagnetic fields
▪ Danger to the environment due to leakage of hazardous substances
▪ Material damage
WILO SE 2019-01