Location Of Identification Data On The Laser Range Meter; Description; Intended Use; Items Supplied - Hilti PD4 Manual De Instrucciones

Printed: 07.07.2013 | Doc-Nr: PUB / 5070017 / 000 / 00
These numbers refer to the corresponding illustrations.
The illustrations can be found on the cover pages. Keep these
pages open when studying the operating instructions. In
these operating instructions, the PD 4 laser range meter is
referred to as "the range meter".
1.3 Location of identification data on the range meter
The type designation and serial number can be found on the
rating plate on the back side of the range meter. Make a note
of this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative or
service department.
Type:
Serial no.:

2. Description

The distance is determined along an emitted laser beam up
to the surface where the laser beam is reflected. The red laser
spot clearly identifies the target from which the measure-
ment is taken.
The measuring range depends on the reflectivity and the sur-
face structure of the target surface.

2.1 Intended use

The range meter is designed for the:
• Measurement of distances

2.2 Items supplied

1 PD 4 laser range meter
1 PDA 60 hand strap
2 Type AA batteries
1 soft pouch
1 Operating instructions
1 Key for battery compartment

3. Technical data

Power supply
3 V DC
Type: AA (LR6, AM3, Mignon)
Standard: two alkaline primary cells
Optional: rechargeable NiMH cells
Battery status indicator
Battery display with four segments showing 100%,
75%, 50% and 25 % charged
No segments visible = empty battery
Measuring range
0.2 m to 70 m (7.5 inch to 210 ft)
The maximum range depends on:
• Reflectivity of the target surface
• Ambient light conditions
en
15