Cleaning The Air Filter; Starter Battery Maintenance; Cleaning The Generating Set; Storing The Generating Set - SDMO DIESEL 6000 E XL C Manual De Utilización Y Mantenimiento

7.5. Cleaning the air filter

Never use petrol or solvents with a low flash point for cleaning the air filter element (risk of fire or explosion).
Important
Remove the nut & the air filter cover (fig. D – No.1 & 2).
Remove the wing nut and the filter elements (fig. D – No. 3, 4 & 5) to clean them:
Foam element:
1) Wash the element in a household cleaning solution & hot water, then rinse thoroughly.
OR: Wash it in a non-flammable or high flash point solvent. Allow the element to fully dry.
2) Dip the element in clean engine oil and remove the excess oil.
Note: The engine will emit smoke during initial start-up if too much oil remains in the lather.
Paper element:
1) Gently tap the element several times on a hard surface in order to remove the excess dirt.
OR: Blow compressed air through the filter, inside-out.
Never try to remove dirt using a brush.
2) Replace the paper element if it is too dirty.
Carefully check that the two elements are not torn or pierced. Replace them if they are damaged.
Check the condition of the rubber gasket (fig. D – No. 6). Replace if necessary.
Refit the filter elements, wing nut, then the cover and its nut.

7.6. Starter battery maintenance

Danger
As the battery is maintenance-free, just check the condition and tightness of the connections and its general cleanliness.

7.7. Cleaning the generating set

Cleaning with a water jet is not recommended.
Cleaning with high pressure cleaning equipment is forbidden.
Important
Remove all dust and debris from around the exhaust.
Clean the generating set, particularly the alternator and engine air inlets and outlets, using a cloth and brush.
Check the general condition of the generating set and replace any faulty parts.

8. Storing the generating set

If the generating set is not used for a long period, it must be stored in accordance with the guidelines below.
Using a suitable container, drain out the fuel and replace the fuel filter (see § Fuel filter replacement)
Start the generating set and allow it to run until it stops due to lack of fuel.
With the engine still warm, change the engine oil and replace the oil filter (see § Renewing engine oil & Replacement of the oil
filter).
Clean the air filter (see § Cleaning the air filter).
Clean the exterior of the generating set, apply an anti-rust product onto the damaged areas.
Cover the generating set with a drop cloth to protect it from dust and store it in a clean & dry location.
Never place the battery close to a flame or fire
Use only insulated tools
Never use sulphuric acid or acid water to top up the electrolyte level.