Models 1010 And 1044 (Black Impact Cap) - MSA Cairns Serie Manual De Uso

5.4.1
2
12
5
11
1 Shell
2 Cap nuts
3 Left bracket
4 Nameplate
5 Screws
6 Faceshield
7 Defender visor
(1)
(2)
(3)
US
(4)
(5)
(6)
(7)
18

Models 1010 and 1044 (Black Impact Cap)

1
4
9
10
Turn the fire helmet upside down.
Remove the ear cover.
Use a Phillips-head screwdriver to remove the four screws that attach the left and right brackets,
MSA nameplates, and cap nuts to the shell.
If applicable, do the following:
a) Use a Phillips-head screwdriver to remove the goggle clips and/or faceshield brackets, then
remove the goggles and/or faceshield.
b) Remove the Defender visor by squeezing the quick-connect locking arms together and
pulling up.
c) Use an adjustable wrench and Phillips-head screwdriver to remove the NFPA-compliant
Bourke lens.
Remove the impact cap assembly from the shell.
If necessary, do the following to remove the suspension from the impact cap:
a) Squeeze to release the four suspension attachment clips, and pull the suspension away from
the impact cap.
b) Squeeze to release the two attachment clips for the additional suspension strap, and remove
the additional suspension strap.
If necessary, do the following to install the suspension in the impact cap:
a) Install the additional suspension strap in the impact cap, and connect the two attachment
clips.
b) Install the suspension in the impact cap, and connect the four suspension attachment clips.
c) Pull up on the suspension to make sure the attachment clips are fully engaged and the
locking tabs are secure.
2
3
4
5
8
6
7
13
8 Impact cap
9 Additional suspension strap
10 Suspension
11 Ear cover
12 Right bracket
13 NFPA-compliant Bourke lens
MSA Cairns Fire Helmets