Models 1010 And 1044 (Grey Impact Cap) - MSA Cairns Serie Manual De Uso

(8) Install the impact cap assembly in the shell.
(9) Do the following on the left and right sides of the fire helmet:
a) Install the MSA nameplate with the MSA logo facing outward, and hold it in position.
b) Install the bracket, and hold it in position.
c) Install the cap nut in the bracket. If the cap nut is seated properly, the bracket acts as a
socket.
d) Use a Phillips-head screwdriver to install the screws through the nameplate, shell, and
bracket into the cap nuts. Do not overtighten or strip the screws.
(10) If applicable, do the following:
a) Install the goggles and/or faceshield, then use a Phillips-head screwdriver to install the
goggle clips and/or faceshield brackets.
b) Install the Defender visor by sliding each quick-connect locking arm into the slot from which
it was removed. The quick-connect mechanisms will click into place when they are fully
engaged
c) Install the NFPA-compliant Bourke lens with an adjustable wrench and Phillips-head screw-
driver.
(11) Install the ear cover.
5.4.2

Models 1010 and 1044 (Grey Impact Cap)

1
2
3
11
5
10
1 Shell
2 Cap nuts
3 Washers
4 Left breakaway tab
5 Screws
6 Faceshield
(1) Turn the fire helmet upside down.
(2) Remove the ear cover and headband.
(3) Use a Phillips-head screwdriver to remove the four screws that attach the right and left break-
away tabs, washers, and cap nuts to the shell.
(4) If applicable, do the following:
a) Use a Phillips-head screwdriver to remove the goggle clips and/or faceshield brackets, then
remove the goggles and/or faceshield.
b) Remove the Defender visor by squeezing the quick-connect locking arms together and
pulling up.
2
3
4
5
8
9
6
7 Defender visor
8 Impact cap
9 Supension
10 Ear cover
11 Right breakaway tab
MSA Cairns Fire Helmets
7
US
19