Models 660C, 664, And Hp3 - MSA Cairns Serie Manual De Uso

(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
5.4.3
US
10
1 Shell
2 Left breakaway tab
3 Screws
4 Impact cap
5 Faceshield
6 Suspension
20
Remove the impact cap assembly from the shell.
Remove all hook-and-loop fasteners on the inside of the shell and outside of the impact cap.
If necessary, do the following to remove the suspension from the impact cap:
a) Unsnap the suspension attachment points from the retaining tabs on the impact cap.
b) Pull the suspension out from the impact cap to remove it..
If necessary, do the following to install the suspension in the impact cap:
a) Install the suspension in the impact cap.
b) Connect the suspension attachment points to the retaining tabs on the impact cap.
c) Pull on the suspension to make sure the suspension attachment points are fully engaged
and secure.
Install hook-and-loop fasteners on the inside of the shell and outside of the impact cap.
Install the impact cap assembly in the shell.
Do the following on the left and right sides of the fire helmet:
a) Install the breakaway tab, and hold it in position.
b) Install the washer and then the cap nut, and hold them in position.
c) Use a Phillips-head screwdriver to install the screws through the breakaway tab, shell, and
washer into the cap nuts. Do not overtighten or strip the screws.
If applicable, do the following:
a) Install the goggles and/or faceshield, then use a Phillips-head screwdriver to install the
goggle clips and/or faceshield brackets.
b) Install the Defender visor by sliding each quick-connect locking arm into the slot from which
it was removed. The quick-connect mechanisms will click into place when they are fully
engaged
Install the headband and ear cover.

Models 660C, 664, and HP3

1
3
9
2
3
4
6 5
7
8
7 Defender visor
8 Headband
9 Ear cover
10 Right breakaway tab
MSA Cairns Fire Helmets