Color Coding; Installation; Installing The Suction Bar - Kärcher BD 80/100 W Classic Bp Manual Del Usuario

Suction bar
19
Suction bar height adjustment
20
Suction bar inclination adjustment
21
Wing nuts for fastening the suction bar
22
Suction hose
23
Fresh water filling level display
24
Fresh water drain hose
Cleaning head lever
25
Water volume regulation knob
26
Suction bar lever
27
Battery plug connector
28
Key-operated switch
29
Display
30
Working speed rotary knob
31
Travel direction switch
32
Waste water tank drain hose with dosing unit
33
** Not in scope of delivery

Color coding

 Control elements for the cleaning process are yellow.
 Control elements for maintenance and servicing are
light gray.
Symbols on the device
Fresh water tank drain opening
Waste water tank drain opening
Increased cleaning head contact pressure
Battery access
Fresh water tank filling level (50%)
Insert the charger plug here
Eyelet point
* Mop holder
ATTENTION
Incorrect socket
Risk of damage
DO NOT insert the charger plug here
Normal cleaning head contact pressure
Raise the cleaning head
Pedal for raising/lowering the cleaning head
Brush replacement pedal
* optional

Installation

Unloading
1. Remove the carton.
2. Remove the straps.
3. Remove the wooden blocks fastened to the pallet by
screws.
4. Using the 3 upper reinforcing boards of the carton pack-
aging (80x24x970 mm) and the board screwed laterally
on the pallet (100x24x970 mm), place a ramp in front of
the pallet and secure it using board pallet screws.
2
Beam 80x60x625 mm
1
Board 80x24x970 mm
2
Board 100x24x970 mm
3
5. Push the beam which has been unscrewed from the pal-
let (80x60x625 mm) under the ramp for support and
screw into place.
6. Press the brake lever down.
Brake lever
1
7. Push the device forwards from the pallet.
8. Press the brake lever up.

Installing the suction bar

1. Insert the suction bar in the suction bar mount.
2. Tighten the wing nuts.
3. Fit the suction hose.
English
3
1
1
7