Lcd Panel Displays - Abbott FreeGo Manual De Uso

LCD PANEL DISPLAYS

Primary Display
Secondary Display
Battery Charge Indicator
AC/Mains LED Indicator
Primary Display: This 4-character display shows the value of the selected dial
parameter. This would include the rate, the dose, or the volume fed, depending on
the pump's dial position. Abbreviated alarm messages will also show here.
Secondary Display: This 12-character display is used to provide additional
information to the user.
Unit of Measure Indicator: This display indicates the unit of measure (mL, hr, mL/
hr) corresponding to the value displayed in the Primary Display.
Battery Charge Indicator: The battery charge status is indicated by battery icon
located on the lower left side of the display. When operating on batteries the
number of bars showing in the battery indicates the amount of battery charge
remaining. When charging the battery bars scroll.
AC/Mains Operation Indicator: AC/Mains-powered operation is indicated by a plug
icon located to the right of the battery icon, as well as an LED light above the dial.
Audio Level Indicator: The audio volume level setting is indicated by this icon.
If the setting is at ALTO (HIGH), there will be two bars
(LOW), the there will be one bar
Feeding Indicator: Four drop icons will scroll in the lower right hand corner of the
display during feeding, incremental priming, or auto priming. Otherwise, the drops
are not present.
Audio Level Indicator
.
44838 Rev. J
Unit of Measure Indicator
Feeding Indicator
. If the setting at BAJO
Page 41