Instructions For Use - Abbott FreeGo Manual De Uso

INSTRUCTIONS FOR USE

TO PREPARE FEED CONTAINER:
1. Depending on your feed container, complete ONE of the following (A, B, or C):
A. If feeding from a Ready-to-Hang (RTH) container, attach either the
Spike or Feedcap feeding set securely onto the pre-filled enteral
nutrition container.
B. If feeding from a RPB (reclosable plastic bottle), attach the Feedcap
feeding set securely onto the pre-filled enteral nutrition container.
C. If feeding from a bag set, unscrew the cap on the bag set, pour in the
feeding solution, and be sure to securely re-screw the cap onto the bag
set to prevent accidental fluid spilling.
2. Hang the feed container (i.e. from a drip stand, from Abbott FreeGo table
drip stand, or inside Abbott FreeGo backpack).
TO PRIME AND LOAD THE FEEDING SET:
1. Complete ONE of the following (Option A or Option B):
Option A
» MANUALLY PRIME THE SET: Gently push the lilac prime tab on the
feeding set cassette against tubing until fluid flows. Completely prime
the set by allowing fluid to expel air from the tubing.
» LOAD THE SET INTO THE PUMP: Open the door on the pump. Grasp
the lilac cassette body on the feeding set and loop the pump insert
around rotor stretching lightly. Gently pull down and then seat the lilac
cassette into the pump. Gently press the tubing to ensure it is fully
seated in slots below the cassette. Close the door firmly.
Or...
Option B
» LOAD THE SET INTO THE PUMP: Open the door on the pump. Grasp
the lilac cassette body on the feeding set and loop the pump insert
around rotor stretching lightly. Gently pull down and then seat the lilac
cassette into the pump. Gently press the tubing to ensure it is fully
seated in slots below the cassette. Close the door firmly.
» AUTO PRIME THE SET: Turn pump dial to FLUJO (SET RATE) or
DOSIS (SET DOSE). Press and hold the Prime Button for two (2)
seconds then release. "CEBANDO" ("PRIMING") will be displayed. Auto
priming will stop when the priming volume has been reached. To stop
this process prior to its completion, press and release the Prime button.
44838 Rev. J
Page 43