Abbott FreeGo Manual De Uso página 47

5. To view the accumulated feeding volume delivered, turn dial to VOL ADM
(VOL FED).
6. To clear the accumulated feeding volume delivered, turn dial to VOL CERO
(CLEAR VOL) (the volume will clear after a five (5) second countdown.)
7. When feeding is complete, turn the pump dial to OFF/CARGA (OFF/
CHRG).
8. Detach the feeding set from the enteral feeding tube.
TO PAUSE FEEDING:
In order to temporarily pause feeding, turn the dial to PAUSA (HOLD). The pump's hold
timer will start its countdown from 5 minutes, by default. The hold time can be manually
changed in one-minute increments, from 1 to 90 minutes, by using the Up and Down
Arrow Buttons. The pump's hold time resets back to this default value every time the
dial is switched away from PAUSA (HOLD). At the end of the countdown, an alarm
will sound, but the PUMP WILL NOT AUTOMATICALLY RESTART. The dial must be
returned to MARCHA (RUN) for the pump to begin feeding again. The hold timer is only
meant as an audio reminder that the feeding was paused.
NOTE: Since feeding only occurs in MARCHA (RUN) mode, feeding may be
temporarily paused by switching the dial from MARCHA (RUN) to any of the other
dial settings. HOWEVER, there is the possibility of changing the feeding parameters
(in FLUJO (SET RATE) or DOSIS (SET DOSE) dial mode) or clearing the
accumulated delivered volume (in VOL CERO (CLEAR VOL) dial mode). Therefore,
it is advised to only use the PAUSA (HOLD) function to temporarily pause a feeding.
TO LOCK THE PUMP:
In order to prevent an unintentional altering of the current numerical values in
FLUJO (SET RATE), DOSIS (SET DOSE) and VOL ADM (VOL FED) (via VOL
CERO (CLEAR VOL)), the pump has a lock-out feature.
NOTE: The PAUSA (HOLD) timer can still be adjusted while the lock-out feature is
activated.
NOTE: The pump will not prime the feeding set while the lock-out feature is
activated.
1. To activate the lock-out feature, simultaneously press both the Up and Down
Arrow Buttons while the dial is in either FLUJO (SET RATE) or DOSIS (SET
DOSE) dial modes. The display will read "ON BLOQUEO ACTIVADO" ("ON
LOCK ON").
2. To deactivate the lock-out feature, repeat the step (1) above. The display
will read "OFF BLOQUEO DESACTIVADO" ("OFF LOCK OFF").
44838 Rev. J
Page 45