Routing Cables; Attaching The Ferrite Core; Connecting The Power Cord - Pioneer PDP-507XG Manual De Instrucciones

Preparation
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma display.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.

Routing cables

Use the speed clamps as necessary to route the connecting
cables. The diagrams below show the location of the holes on the
rear of the display.
PDP-427XG (rear)
PDP-507XG (rear)
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma display
and snap [2] into the back of [1] to lock the clamp.
1
• Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
• Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
• Be careful not to subject any connecting cables to strain.
2
Tidying the speaker cables (PDP-507XG only)
Use the supplied bead bands as necessary to tidy the speaker
cables.
Bead band

Attaching the ferrite core

To help prevent noise, attach the supplied ferrite core to the
connector end of the power cord as shown. Use the supplied cable
tie to prevent the ferrite core from slipping on the cable.
1
2
To power outlet
AC power cord
Note
• Disconnect the power cord from the power outlet when the
plasma display is not going to be used for a long period of time.

Connecting the power cord

PDP-427XG (rear view)
Speaker cables
4
3
Ferrite core
Cable tie
As close as possible
Power cord
To power outlet
05
17
En