Basic Connections; Connecting The Antenna; Routing Cables - Pioneer PDP-5080XA Manual De Instrucciones

Preparation

Basic connections

Connecting the antenna

To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
Rear view
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• Connect a 75-ohm coaxial cable (commercially available) to the
ANT terminal.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma television.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.
All manuals and user guides at all-guides.com

Routing cables

When the speaker is installed under the plasma television panel (for
PDP-5080XA only):
Rear view
• Use the supplied bead bands as necessary.
• When tidying up your speaker cables, make sure to bundle them
Attaching speed clamps to the main unit
Use the speed clamps as necessary to route the connecting cables.
The diagrams below show the location of the holes on the rear of the
plasma television.
(PDP-5080XA)
(PDP-4280XA)
Speaker cable
Bead band
Note
so that they are not subjected to any pressure.
05
17
En