Serial Cable Installation; Special Turbo-V 1K-G Navigator Controller Installation - Agilent Technologies Special Turbo-V 1K-G Manual De Instrucciones

Serial Cable Installation

The supplied serial cable must be installed when the Special Turbo-V
1K-G or the optional vent valve have to be controlled by means of a
remote computer.
The cable is installed fixing the 9 pin D-type connector into the P2
serial connector as shown in the following figure.
Figure 36

Special Turbo-V 1K-G Navigator Controller Installation

The controller can be mounted on the pump bottom.
To install the controller execute the following procedures.
Special Turbo-V 1K-G User Manual / 87-901-006-01 (A)
Technical Information

Serial Cable Installation

SERIAL CABLE
17
247/258