Row Marker Disk Adjustment - GASPARDO SARA Empleo Y Mantenimiento

3.15.2 ROW MARKER DISK ADJUSTMENT

Attach the disc holding sleeve (1 Fig. 33) onto the two arms of the
row marker, without overtightening the nuts, insert the disc and
secure it in place by means of the snap pin. Using the table
shown, read the dis-tance (L Fig. 30) at which the disc is to draw
the reference line. Regulate the disc at the correct distance, tilt it
slightly and firmly tighten the nuts (Fig. 34).
For normal soils the correct working position of the disc is that
shown in Fig. 35 ref. A; for strong soils turn it over as shown in ref.
B Fig. 35. For distances not covered by the table, use the following
rule:
L= D (N +1) - C
where:
L= the distance between the outer most unit and the row marker
D= the distance between the rows
N= the number of units operating
C= the tractorís front wheelbase
D = 75 cm;
N = 6 units;
C = 190 cm
L = 75 (6 + 1) - 190 = 167,5 cm
For travelling on the road, turn the row marker discs so
that they come within the overall dimensions of the
machine (Fig. 36) and secure the row markers to the
frame using the safety pins provided.
cod. G19502521
2
Example:
2
WARNING
USE AND MAINTENANCE
fig. 34
Avanzamento
Table 2
Advancement
Avancement
fig. 35
fig. 36
g
1
nr 17
ENGLISH
fig. 33
A
B
49