Use of the machine - User Manual
4.10
Installation and use of the cappuccinatore (optional)
The cappuccinatore is an optional accessory which can be purchased sepa-
rately.
The cappuccinatore allows you to easily and quickly prepare delicious cap-
puccinos.
Danger of scalding! At the beginning, short spurts of hot water
may come out. The steam spout may reach high temperatures: do
not touch it with bare hands.
Install the cappuccinatore as shown in the fi gures.
Unscrew the steam spout from its seat. Keep the steam spout in a safe place
for later use as beverage heater.
Remove the cappuccinatore from its packaging and clean it thoroughly as de-
scribed in section 6.6.
Screw it where the steam spout was previously installed.
Once installed, proceed as follows to clean the suction pipe: clean the outside
of the suction pipe with a damp sponge, immerse it into a container with fresh
drinking water and dispense steam after directing the cappuccinatore into a
container.
Wait until a little water fl ows out of the cappuccinatore before interrupting steam
dispensing.
• 32 •
Insert the suction pipe into the milk container to use the cappuccinatore. Make
sure that the tube is immersed in the milk.
Place a cup beneath the cappuccinatore.
Press the steam button (Fig. 16, pag. 3) for 1 second so as to let the remain-
ing water come out of the steam spout. When only milk comes out, press the
steam button to stop dispensing. Empty the cup. Press the steam button for
1 second so as to restart dispensing steam. In a short time, frothed milk will
come out directly into the cup. The display shows:
¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼
Saeco Office One
¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼
Steam
¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼
Press a key
to end
¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼¼
Note: Adjust the froth consistency by turning the knob (A) located
on the cappuccinatore.
When the desired amount of milk has been frothed, press the button (Fig. 16,
pag. 3) again to stop dispensing.
It is now possible to dispense your favourite coffee directly into the cup to enjoy
an excellent cappuccino.
Note: wash the cappuccinatore immediately after use. This will al-
low you to always maintain it in perfect working order. Clean the
outside of the milk suction pipe with a damp sponge.
To wash the cappuccinatore, direct it on a container and proceed as follows.
Immediately after use, immerse the suction pipe into a container with fresh
drinking water.
A