Modifying The Wheel Rotation Direction - SOMFY Sonesse 28 WireFree RTS Li-ion Manual De Instrucciones

Sonesse 28 WireFree RTS / Sonesse ULTRA 30 WireFree RTS

2.4.4. Modifying the wheel rotation direction

1) Using the UP or DOWN button on the control point, move
the driven product away from the end limits.
2) Press and hold the UP and DOWN buttons simultaneously
until the driven product briefly moves Up and Down and
orange LED starts to blink slowly.
3) Press the UP, MY and DOWN buttons simultaneously, until
the driven product briefly moves Up and Down, wheel
rotation is reversed and green LED blinks 5 times.
2.4.5. Erasing control points from memory
To delete all the programmed control points, press and hold the
motor head programming button until the driven product briefly
moves Up and Down twice. All programmed control points are
deleted and green LED blinks 5 times.
2.4.6. Erasing the memory of the motor (factory default)
To reset the motor, press and hold the motor head program-
ming button until the driven product briefly moves Up and Down
3 times.
All the settings are erased. Green LED blinks 5 timest then or-
ange LED is fixed on.
2.4.7. Temporary sleeping mode
Attention
The driven product must be programmed.
The drive will not respond to any control points commands for 15 minutes.
1) Press and hold the motor head programming button until
the driven product briefly moves Up and Down.
2) Briefly press the motor head programming button, the
driven product briefly moves Up and Down twice. "Sleeping
mode" is activated, green LED blinks 5 times to confirm,
then orange LED blinks every second as long as the motor
is in the temporary sleeping mode.
3) To deactivate the "Sleeping mode", briefly press the motor
head programming button. The driven product briefly moves
Up and Down, the control point commands are enabled.
Green LED blinks 5 times.
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
1
2 3
1
2
3
EN
2x
3x
2x
7