Adjusting The Turn Signal - Gazzini 10030302 Instrucciones De Uso

²
12
= 7.46
19.3
A 7.5 ohm resistor is required (not included).
The resistors are available partly pre-wired, so they are very easy to install, and it
is impossible to connect them incorrectly.
You must pay attention to the load range for which universal flashers are
intended to be used and whether there are one or two turn signal indicator lights
on the vehicle. If there is only one common turn signal indicator light for the
right-hand and left-hand flasher, one hazard warning flasher or one acoustic turn
signal monitor, it may be simpler to work with resistors.
CAUTION!
Risk of accident!
It is imperative that you bear in mind that when electronic flasher
relays are used, the failure of a turn signal is no longer indicated
by the indicator light, which could put you at risk of an accident.
You should therefore check that your turn signals are fully
functional before the start of every journey.

4.5 | Adjusting the turn signal

Horizontal
20°
80°
At an attachment height of < 750 mm the lower angle can be reduced to 5°.
The turn signal, i.e. mirror, must be aligned as per the diagram in order to ensure
proper emission and a good view of the road behind you at the same time.
22
Vertical
15°
15°