Installation; Electrical Connection - Gazzini 10030302 Instrucciones De Uso

4.3 | Installation

Carefully screw the compatible gazzini thread adapter (No. 7, 8, 9) into the mirror
joint (Nr. 4). Then screw the base or the mirror joint, with the adapter attached, into
the lever assembly. Roughly align the mirror to suit your riding position and tighten
it using the lock nut (size 15 wrench). Then, once the mirror has been aligned to the
riding position, fasten the Flat head screw (Nr. 2) and toothed lock washer (Nr. 3)
on the mirror stem to the mirror joint using a hexagon key (size 4). Then adjust the
mirror head on the ball joint so that you have an optimal view of following traffic.

4.4 | Electrical connection

LED turn signals only light up if the positive cable (+) and the negative cable (-)
are connected correctly. The cables have small marker tags for identification.
Connect the red positive cable (+) and the black negative cable (-) of the turn
signal to the supply lines of the removed original turn signal. For this purpose
there are various options, e.g. using the supplied Japanese connector as an
aid, with seal connectors (sold separately) or with small soldered joints. It is
imperative that the soldered joints are insulated with heat shrink tubing. To do so,
the heat shrink tubing is pushed onto the cable before the cable is soldered. Then
pull the heat shrink tubing over the soldered joint and carefully shrink it on with a
cigarette lighter or a hot air gun.
To make the electrical connection particularly simple, there are specific
adapter cables optionally available for a wide range of vehicles. At
one end, the adapter cables have a compact connector that fits into
the plug-in connector of the original wiring harness and, at the other
end, the necessary connections for the turn signal. You do not require any other
materials whatsoever for making the electrical connections.
20
3
2
4
7 8 9