Important - FAAC 630 Manual Del Usuario

9. ACCESSORIES
SKIRT KIT
The skirt kit serves to increase barrier visibility.
It is available in lengths 2 m and 3 m.
IMPORTANT: If a skirt is fitted the balance spring will have
to be adapted.
ARTICULATION KIT
The articulation kit allows the rigid beam to be articulated
to a maximum ceiling height of 3 metres.
IMPORTANT : If the articulation kit is fitted the balance
spring will have to be adapted.
SUPPORT FORK
The support fork performs two functions:
- It prevents the beam from bending or breaking if excessive
force is applied at its end.
- It acts as a rest for the beam in the closed position and
prevents the beam from flexing downwards.
POSITIONING OF SUPPORT FORK BASE PLATE
fig. 12
Values are expressed in mm
To position the support fork base plate, refer to fig. 15,
where:
P1 = barrier base plate
P2 = support fork base plate
L = beam length (in mm)
A = L - 395 (in mm)
10. MAINTENANCE
When performing maintenance always check that the by-
pass screws are set correctly, that the system is balanced
and that the safety devices operate correctly.
10.1. TOPPING UP WITH OIL
Check periodically the quantity of oil inside the tank.
For medium/low duty cycles a yearly check is sufficient; for
more severe operation it is advisable to check every 6
fig. 13
months.
The level must not fall below the level mark on the inspection
window (4, fig. 1).
To top up, unscrew the filler cap (6, fig. 1) and pour in oil
up to the correct level.
Use exclusively FAAC XD 220 oil.
10.2. BLEEDING AIR FROM HYDRAULIC CIRCUIT
If the beam moves in an irregular manner, this may be due
to the presence of air in the hydraulic circuit.
If it is necessary to bleed the air, proceed as follows:
1) Check that the breather screws have been removed
(fig. 6).
2) Disassemble the beam and the spring / pivot arm unit
from the splined shaft.
3) Set an operating time of about 1 minute on the
fig. 14
electronic control unit.
4) Activate the operator electrically so that it turns to the
end of its travel in both directions of rotation.
5) Repeat this operation several times if necessary.
6) Follow the installation instructions to reassemble.
11. REPAIRS
For repairs, contact an authorised FAAC Service Centre.
13
P1
305 A
L
.
ENGLISH
P2
90
fig. 15