GreenWorks 20332 El Manual Del Propietario página 19

OPERATION
PROPER cUTTING STANcE (See Fig. 10)
• Balance your weight with both feet on solid ground.
• Keep left arm with elbow locked in a "straight arm" position to withstand any kickback force.
• Keep your body to the left of the chain line.
• Keep your thumb on underside of handlebar.
bASIc OPERATING/cUTTING PROcEdURES
Practice cutting a few small logs using the following technique to get the "feel" of using the saw
before you begin a major sawing operation.
• Take the proper stance in front of the wood.
• Press the switch lock and squeeze the switch trigger, then release switch lock and let the
chain accelerate to full speed before entering the cut.
• Begin cutting with the saw against the log.
• Keep the unit running the entire time you are cutting, maintain a steady speed.
• Allow the chain to cut for you; exert only light downward pressure. forcing the cut could
result in damage to the bar, chain, or motor.
• Release the trigger switch as soon as the cut is completed, allowing the chain to stop. If you
run the saw without a cutting load, unnecessary wear can occur to the chain, bar, and unit.
• Do not put pressure on the saw at the end of the cut.
THUMB ON
UNDERSIDE OF
HANDLE BAR
Fig. 10
CHAIN
LINE
19
STRAIGHT
ARM