Storing The Product - GreenWorks 20332 El Manual Del Propietario

MAINTENANCE

STORING THE PROdUcT

• Clean all foreign material from the product. Store it in a well-ventilated place that is
inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-
icing salts.
• Always place the scabbard on the bar and chain before storing or transporting the chainsaw
• Use caution to avoid the sharp teeth of the chain
QUIcK REFERENcE OF cHAIN&bAR ASSEmbLY (KNOb TENSION)
1, To remove the side cover,
loosen the locking knob one
full turn counterclockwise.
4, The bar and chain can now
be removed by lifting it away
from the main body of the
saw and releasing the chain
from the drive pulley.
7, Ensure that the adjusting
b l o c k i s l o c a t e d i n t h e
tensioning hole on the chain
bar.
10, Turn the tension knob
clockwise to tighten the chain.
NOTE: 1) Chain stretch with use, check and tensiion often.
2) Never tension a warm chain before storing, as chains shrink when cool, this can damage chain , bar
and saw.
2, Then loosen the chain
tension knob 2 or 3 turns.
5, The chainsaw can now be
cleaned with a brush or a rag
to remove sawdust and oil
8, And that the rubber block
and chain bar are free from
oil, as this helps to keep
tension on the chain.
11, Until there is enough play
that the chain can be pulled
away from the bar, but not so
much that the runners can be
pulled out of the bar.
36
3, Now totally remove the
locking knob and remove the
side cover.
6, To replace the bar and
chain, loop the chain over the
drive pulley and place the bar
against the centre alignment
groove.
9, Replace the side cover
and locking knob, but do not
tighten.
1 2 , O n c e y o u h a v e t h e
correct tension, fully tighten
the locking knob.