GreenWorks 20332 El Manual Del Propietario página 22

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
• Consider the force and direction of the wind, the lean and balance of the tree, and the location
tree along a line different from its natural line of fall.
• Remove dirt, stones, loose bark, nails, staples, and wire from the tree where felling cuts are
to be made.
Notched Undercut:
• Cut a notch about 1/3 the diameter of the trunk in the side of the tree. Make the notch cuts
so they intersect at a right angle to the line of fall. This notch should be cleaned out to
leave a straight line. To keep the weight of the wood off the saw, always make the lower
cut of the notch before the upper cut.
Felling Backcut:
• As the felling cut gets close to the hinge, the tree should begin to fall. If there is any
chance the tree may not fall in the desired direction or it may rock back and bind the saw
chain, stop cutting before the felling cut is complete, and use wedges of wood, plastic or
aluminum to open the cut and drop the tree along its desired line of fall. Make the backcut
level and horizontal, at least 2" (5 cm) above the horizontal cut of the notch.
NOTE: Never cut through to the notch. Always leave a band of wood between the notch and back cut
(approximately 2" (5 cm) or 1/10 the diameter of the tree). This is called "hinge" or "hingewood." It controls the
fall of the tree, and prevents slipping or twisting or shootback of the tree off the stump.
• On large diameter trees, stop the back cut before it is deep enough for the tree to either fall
or settle back on the stump. Then insert soft wooden or plastic wedges into the cut so they do
not touch the chain. Drive wedges in, little by little, to help jack the tree over.
• As tree starts to fall, stop the chainsaw and put it down immediately. Retreat along the cleared
path, but watch the action in case something falls your way.
W A R N I N G
Never cut through to the notch when making a back cut. The hinge controls the fall of the tree. This
is the section of wood between the notch and backcut.
2" or 1/10 DIA
BACK CUT 2"
HINGE
NOTCH -
APROX. 1/3
DIAMETER OF
TRUNK
BACK CUT
22
HINGE
Fig. 13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido