Operation - GreenWorks 20332 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION

W A R N I N G
Do not allow familiarity with this product to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
W A R N I N G
Always wear safety goggles or safety glasses with side shields that comply with ANSI Z87.1 when
operating power tools. Failure to do so could result in objects being thrown into your eyes, resulting
in possible serious injury.
W A R N I N G
Do not use any attachments or accessories not recommended by the manufacturer of this product.
The use of attachments or accessories not recommended can result in serious personal injury.
APPLIcATIONS
You can use this product for the purposes listed below:
• Basic limbing, felling, and woodcutting
• Removing buttress roots
AddING bAR ANd cHAIN LUbRIcANT (See Fig. 6)
Use a lubricant that is designed for chains and chain oilers, and is formulated to perform over a
wide temperature range with no dilution required.
NOTE: The chainsaw comes from the factory with no bar and chain oil added. Level should also be
checked after every 20 minutes of use, and refilled as needed.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil.
• Check and fill the oil tank when quick-view oil indicator is below the MIN. line.
• Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank
after each use, then run for one minute. When storing the unit for a long period of time (three months or
longer), be sure the chain is lightly lubricated. This will prevent rust on the chain and bar sprocket.
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido