Indications And Displays On The Receivers - Sennheiser evolution wireless Serie Instrucciones Para El Uso

EM 100 G2
EK 100 G2

Indications and displays on the receivers

Operation and battery status indication (EK 100 G2 only)
The red LED (LOW BAT/ON)
state of the EK 100 G2:
Red LED lit up: The receiver is switched on and the capacity of the bat-
teries/accupack BA 2015 is sufficient.
Red LED flashing: The batteries are/the accupack BA 2015 is going flat
(LOW BAT)!
In addition, the 4-step battery status display
information on the remaining battery/accupack BA 2015 capacity:
3 segments:
2 segments:
1 segment:
Battery icon flashing:
Transmitter battery status indication (EM 100 G2 only)
When the capacity of the transmitter batteries/accupack is so low that the
batteries/accupack must soon be replaced (LOW BAT), the transmitter trans-
mits information on its remaining battery/accupack capacity to the
EM 100 G2 receiver and the transmitter low battery icon
the receiver display panel.
"MUTE" display
The "MUTE" display or
the RF signal of the received transmitter is too weak,
the received transmitter has been muted (with the pilot tone transmission
or evaluation activated).
RF signal indication (EK 100 G2 only)
The green LED (RF) at the front of the EK 100 G2 lights up when an RF sig-
nal is being received.
provides information on the current operating
on the display panel provides
capacity approx. 100 %
capacity approx. 70 %
capacity approx. 30 %
LOW BAT
appears when
starts flashing on
11