Indications And Displays On The Transmitters - Sennheiser evolution wireless Serie Instrucciones Para El Uso

Indications and displays on the transmitters

Operation and battery status indication
The red LED (LOW BAT/ON) provides information on the current operating
state of the transmitter:
Red LED lit up: The transmitter is switched on and the capacity of the
batteries/accupack BA 2015 is sufficient.
Red LED flashing: The batteries are/the accupack BA 2015 is going flat (LOW
BAT)!
In addition, the 4-step battery status display
information on the remaining battery/accupack BA 2015 capacity:
3 segments:
2 segments:
1 segment:
Battery icon flashing:
"MUTE" display
The "MUTE" display appears on the display panel when the transmitter is
muted (see: „Muting the transmitters" on page 23).
Modulation display
The level display for audio signal (AF) shows the modulation of the transmit-
ter.
AF peak indication (SK 100 G2 only)
The yellow LED (AF PEAK)
audio input level is excessively high (AF peak) and overmodulates the trans-
mitter. At the same time, the 7-step level display for audio signal "AF" shows
full deflection for the duration of the overmodulation.
"PILOT" display
The "PILOT" display lights up when the transmitter display panel if the
pilot tone transmission is activated (see: „Activating/deactivating the pilot
tone transmission or pilot tone evaluation" on page 35).
Display backlighting (SK 100 G2 only)
After pressing a button, the display remains backlit for approx. 15 seconds.
on the display panel provides
capacity approx. 100 %
capacity approx. 70 %
capacity approx. 30 %
LOW BAT
at the front of the SK 100 G2 lights up when the
13