Selecting The Standard Display; Entering A Name - Sennheiser evolution wireless Serie Instrucciones Para El Uso

IMPORTANT!
DISPLY
selectable
Standard display
EM 100 G2
„FREQ"
„NAME"
„CHAN"
NAME
34
Notes:
If the squelch threshold is adjusted too high, the transmission range will
be reduced. Therefore, always adjust the squelch threshold to the lowest
possible setting. The squelch threshold is factory-preset to "LO".
When in the setting mode of the "SQELCH" menu, pressing the
(DOWN) for more than three seconds will switch the squelch off. "SQ.OFF"
appears on the display. If no RF signal is being received, hissing noise will
occur. This setting is for test purposes only.

Selecting the standard display

Via the "DISPLY" menu, you can select the standard display:
Contents of standard display
EK 100 G2
⎯

Entering a name

Via the "NAME" menu, you can enter a freely selectable name for each trans-
mitter and receiver. You can, for example, enter the name of the performer
for whom the adjustments have been made.
The name can be displayed on the standard display and can consist of up to
six characters such as:
letters (without pronounciation marks),
numbers from 0 to 9,
special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
Press the SET button to get into the setting mode of the "NAME" menu.
The first segment starts flashing on the display.
With the / buttons you can now select a character. By briefly pressing
a button, the display jumps either forwards or backwards to the next cha-
racter. If you hold down a button, the display starts cycling continuously.
Press the SET button to change to the next segment and select the next
character.
Have you entered the name completely? Press the
your setting and to return to the previous menu level.
button
SK 100 G2, SKM 100 G2,
SKP 100 G2
SET button to store