Skm 100 G2 Radiomicrophone - Sennheiser evolution wireless Serie Instrucciones Para El Uso

20
Plugging the plug-on transmitter onto a microphone
Plug the transmitter's XLR-3F socket
Tighten the locking ring
Note:
The transmitter uses the microphone body as an antenna – therefore only
microphones with a metal casing should be used for best signal transmission.

SKM 100 G2 radiomicrophone

Inserting and replacing the batteries
For powering the SKM 100 G2 radiomicrophone, you can either use two 1.5 V
AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
Unscrew the display section
turning it counterclockwise.
Slide back the display section
Open the battery compartment cover
Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
Close the battery compartment cover
Push the battery compartment into the radiomicrophone's body.
Screw the display section tight.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries" on page 19.
onto the microphone's XLR-3M socket.
as shown in the diagram on the left.
from the radiomicrophone's body
as far as it will go.
.
.
by