Sk 100 G2 Bodypack Transmitter - Sennheiser evolution wireless Serie Instrucciones Para El Uso

18
Mounting the bodypack receiver to a camera
Use the supplied camera kit to mount the receiver to the camera's flash
mount.
The camera kit consits of:
1 perforated plate
1 flash mount adapter
2 square nuts
Determine where on the perforated plate the flash mount adapter
need to be fastened so that the receiver can best be attached to the
camera.
At this position, place a square nut
Fasten the flash mount adapter to the perforated plate using the square
nut.
Remove the belt clip.
Place the perforated plate
Reinsert the belt clip.

SK 100 G2 bodypack transmitter

Inserting and replacing the batteries
For powering the SK 100 G2 bodypack transmitter, you can either use two
1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
Press the two unlocking buttons
cover .
Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
Close the battery compartment. The battery compartment cover
into place with an audible click.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries" on page 17.
Connecting the microphone/line cable
The microphone/line input is designed for the connection of both condenser
microphones and instruments (e.g. guitars). DC powering of the condenser
microphones is via the microphone/line input.
Connect the 3.5 mm jack plug
3.5 mm jack socket (MIC/LINE)
Lock the 3.5 mm jack plug by screwing down the coupling ring
Via the operating menu, adjust the sensitivity of the microphone/line
input (MIC/LINE) (see: „Adjusting the sensitivity (transmitters only)" on
page 32).
under the perforated plate
onto the rear of the receiver.
and open the battery compartment
from the microphone/line cable to the
.
will
.
locks
.