EN 48
PROBLEM
12. Unusual vibrations
while working
13. With the engine
running, the machine
does not move when
the drive pedal is
➤
pressed (
for
hydrostatic drive
models)
If problems continue after having carried out these operations, contact a Licen-
sed Service Centre.
WARNING!
!
have the necessary equipment and the technical knowledge. The gua-
rantee is automatically revoked and the manufacturer declines all
responsibility for any repairs which are badly done.
LIKELY CAUSE
– the blades are imbalanced
– blades loose
– fixing bolts loose
– disengage lever in position «B»
(☛ 4.33)
Do not take on complicated repair work if you don't
TROUBLESHOOTING
SOLUTION
– balance or replace any damaged bla-
des (☛ 6.3.1)
– check that the blades are firmly fitted
(☛ 6.3.1) (remember the left-hand
thread of the right-hand blade)
– check and tighten all the fixing bolts of
the engine and frame
– put into position «A»