Transporting; Advice On How To Obtain A Good Cut - EMAK EF92C/13,5M Manual Del Operador

HOW TO USE THE MACHINE
Control of the machine may be lost, particularly on slippery surfaces.
➤
For mechanical drive models:
DANGER!
!
with the clutch out! Always engage a low gear before leaving the machi-
ne stopped and unattended.
➤
For hydrostatic drive models:
Go down slopes without touching the pedal (☛ 4.32) to take advantage of the
braking effect of the hydrostatic drive when the transmission is not engaged.

5.6 TRANSPORTING

WARNING!
!
suitable equipment for lifting and an appropriate number of people for the
weight involved and the type of lifting system used. The machine must
never be lifted by rope and tackle. While being transported, close the fuel
➤
stopcock (
and fasten the machine securely with ropes or chains to the hauling devi-
ce.

5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT

1. To keep a lawn green and soft with a good appearance it should be cut regu-
larly without damaging the grass.
2. It is always better to cut the grass when dry.
3. The blades must be in good condition and well sharpened so that the grass is
cut straight without any ragged edge that leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of the grass and
to get the necessary thrust to push the cuttings through the collector channel.
5. The frequency of mowing should be in relation to the rate of growth of the
grass, which should not be left to grow too much between one cut and the next.
Never ride the machine on slopes in neutral gear or
If the machine is transported on a truck or trailer, use
if fitted), lower the cutting deck, engage the parking brake
EN 33