EMAK EF92C/13,5M Manual Del Operador página 97

MAINTENANCE
6.4.3 R
EPLACING BULBS
The bulbs (18W) have a bayonet fitting
and are installed in the bulb holder which
can be taken out by turning it anti-clockwi-
se, using pliers.
6.4.4 R
EPLACING A FUSE
The general and power circuits of the elec-
trical system are protected by a 6.3 A
delayed fuse (1).
When the fuse blows, the machine stops
and the light on the dashboard goes out.
IMPORTANT
type and ampere rating, and never with one of another rating.
If you cannot find out why the fuse has blown, consult a Licensed Service Centre.
6.4.5 R
EPLACING BELTS
Replacing belts is quite a complicated process of dismantling and subsequent
adjustment and must only be carried out by a Licensed Service Centre.
NOTE
wear! ALWAYS USE GENUINE REPLACEMENT BELTS!
➤
( if fitted)
A blown fuse must always be replaced by one of the same
Replace the belts as soon as they show obvious signs of
EN 45
1 (6.3 Amp)