EMAK EF92C/13,5M Manual Del Operador página 77

HOW TO USE THE MACHINE
– the transmission is not in neutral («N»).
– the operator is absent with the parking brake disengaged.
In these cases, once the situation has been corrected, the key must first be tur-
ned back to «OFF» before the engine can be restarted.
5.4.2 S
TARTING AND MOVING WITHOUT MOWING
WARNING!
!
roads. It has to be used (as indicated by the highway code) in private
areas closed to traffic.
NOTE
and the cutting deck put at its highest position (position «7»).
➤
For mechanical drive models:
Put the accelerator control between the «SLOW» and «FAST» positions, and
the gear change lever in the 1st speed position (☛ 4.22).
Keep the pedal pressed down and disengage the parking brake. Slowly relea-
se the pedal which will turn from «brake» to «clutch», thus operating the rear
wheels (☛ 4.21).
WARNING!
!
engagement may cause tipping up and loss of control of the vehicle.
Gradually reach the desired operating speed using the accelerator and gear
lever. To change the gear speed the clutch must be used pushing the pedal
half way down (☛ 4.21).
➤
For hydrostatic drive models:
When moving the machine from one area to another, put the accelerator lever
in a midway position between «SLOW» and «FAST».
Disengage the parking brake and release the brake pedal (☛ 4.31).
Press the drive pedal (☛ 4.32) in direction »F» and reach the required speed
by progressively increasing pressure on the pedal and moving the accelerator
appropriately.
This machine has not been approved for use on public
When moving the machine, the blades must be disengaged
The pedal has to be released gradually as a sudden
EN 25