EMAK EF92C/13,5M Manual Del Operador página 80

EN 28
– disengage the blades (☛ 4.7) and the audi-
ble signal will stop;
– press the button (1) that releases the
emptying system and move it to the retrac-
ted position so that it stays pressed down;
– pull out the lever (2) and tip up the grass-
catcher to empty it;
– close up the grass-catcher so that it hooks
onto the pawl (3).
NOTE
ning may be heard at the moment of enga-
ging the blade even when the grass-catcher
has been emptied. This is due to grass-cut-
tings left on the sensor (4) of the micro-swit-
ch. To stop the signal, disengage the blade
and then immediately engage it again.
Always keep the sensor (4) free of grass-cut-
tings.
5.4.7 U
NBLOCKING THE COLLECTOR CHANNEL
Cutting very tall or wet grass, particularly at too high speed, can cause the collec-
tor channel to become blocked. Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades and stop the engi-
ne;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the exit of the collector
channel.
WARNING!
!
off.
5.4.8 E
ND OF MOWING
When you have finished mowing, disengage the blades, lower the engine speed
and ride the machine with the cutting deck in the highest position.
At times the audible war-
This job must only be performed with the engine turned
HOW TO USE THE MACHINE
2
1
3
4