Microlife BP3AX1-4U Manual De Instrucciones página 16

Press OK and the display shows graph of
all data.The lines indicate the Systolic (top
end) and Diastolic (bottom end) values.
Press or to move the cursor between
measurements. The currently selected
measurement is indicated by a blinking line.
Press ON/OFF/START to exit this mode.
6.2. Setting the User
This monitor allows you to track readings
for two individuals independently. Scroll to
User and press OK to enter the submenu.
Press or to make your selection. Select
to set the device to not save readings.
Select to select user 1. Any readings
made when user 1 is selected will be
stored only in memory 1.
Select
when user 2 is selected will be stored only
in memory 2.
Note: There is a User 0, which does not store
memories. If your unit is on the User 0 setting,
no readings will be stored in memory.
After selecting user 1 or user 2 you are
prompted to enter the user name. You can
use up to six characters.
To keep the default name «User_1», press
ON/OFF/START. To enter a different name,
follow these instructions:
Press or to scroll through the
alphanumeric characters A ~ Z and 0 ~ 9.
There is also one underscore and one space
No.7 3/06
200
150
100
50
4/17 - 4/18
USER
*A friend can measure their blood
pressure without saving it in
memory by setting the user to the
symbol (User 0).
15:48
SYS
145
DIA
85
PUL
98
AVG MAM
13